 |
|
|
|
Replacing a
Density System
Power Supply
Power Supply Replacement
Density Series uses sealed modular power supplies. Perform the following steps to replace a power supply.NOTE!
The Density Series system requires two power supplies to provide power
to server
groups. Do not remove more than one power supply from the chassis without
first shutting off power to all groups
Loosen the two retaining screws that secure the power supply to the chassis (figure 1).
Figure 1, Power Supply Retaining Screws
Grasp the power supply handle and pull the power supply out of the chassis.Insert the replacement supply.
Secure the retaining screws.
Connect the power cord.
Systems | Circuit Boards | Other Products | Software | Hardware Identifier
Other Vendors | Technical Notes | Downloads | Search | Support Home Page
This document, and all
Web Site contents, Copyright ©
2000 by Cubix Corp., Carson City, NV, USA.
