Support Home Page
Cubix Home Page
Feedback Forms

Replacing a Density System
Floppy Disk Drive


Floppy Drive Replacement

Remove the top front cover of the chassis by loosening the two rear screws and removing the two front screws (figure 1).

 

floppy1.jpg (116269 bytes)

Figure 1, Top Front Cover Removal

Remove two screws securing the floppy disk drive assembly plate to the disk drive bay (figure 2).

floppy2.jpg (88715 bytes)

Figure 2, Removal of floppy drive assembly securing screws

Slide the floppy drive out of the hard drive chassis enough to expose the rear connectors (figure 3).

floppy3.jpg (57542 bytes)

Figure 3, Removal of Floppy Disk Drive Cables

Disconnect the floppy ribbon and power cables from the rear of the floppy drive assembly.

Remove the four screws securing the floppy drive to the mounting assembly.

Reverse the steps above to install the replacement drive.


Systems | Circuit Boards | Other Products | Software | Hardware Identifier
Other Vendors | Technical Notes | Downloads | Search | Support Home Page

This document, and all Web Site contents, Copyright ©
2000 by Cubix Corp., Carson City, NV, USA.