Support Home Page
Cubix Home Page
Feedback Forms

SP 5200XS Series
On-Board Ethernet Adapter

The board is equipped with an integral DEC 21140 PCI fast Ethernet controller with a RJ-45 10/100 BASE-T connector on the mounting bracket at the rear of the board.

The adapter is enabled or disabled via the "Chipset" option of the BIOS Setup utility and via hardware with a jumper (see the Quick Reference Guide for jumper settings).

The I/O addresses and interrupts are set by the PCI plug and play BIOS at boot time.

Eb015.gif (2775 bytes)

Ethernet Adapter LED's

Near the RJ-45 connector and visible in the mounting bracket are two sets of light emitting diodes (LED).

On the upper set:

  • The green LED indicates network activity.
  • The amber LED indicates a data collision on the network. These LEDs can be useful indicators of network activity.

On the lower set:

  • The green LED will light when the interface has a valid connection to an Ethernet hub.
  • The amber LED will light when the interface is set to 100 Mbit/s.

 

Drivers

DEC 10/100 Base-T drivers can be downloaded by clicking on the link below.

DEC 10/100 Base-T Ethernet Drivers

Systems | Circuit Boards | Other Products | Software | Hardware Identifier
Other Vendors | Technical Notes | Downloads | Search | Support Home Page

This document, and all Web Site contents, Copyright ©
2000 by Cubix Corp., Carson City, NV, USA.