BC & DP Series
NetWare Software Installation Guide

BCACTIVE

BCACTIVE.NLM is a NetWare Loadable Module (NLM) that supports the Cubix IES Supervisory System by providing an interface between the IES module and a  BC processor running NetWare 3.x\4.x.

Installing BCACTIVE.NLM

To install Cubix IES Supervisory support on a BC processor running NetWare:

1. Install the BCSETUP.SYS device driver on the DOS partition of the NetWare Server as previously explained in the DOS Environment Installation section.

Note: Both BCSETUP.SYS and BCACTIVE.NLM must be installed with the same interrupt configuration.

2. Copy the file BCACTIVE.NLM from the NetWare subdirectory of the BC Series Software Installation Diskette to the SYSTEM subdirectory of the SYS volume of the NetWare server.

3. Add the following line to the AUTOEXEC.NCF file on the NetWare partition:

load bcactive 15 

This will load BCACTIVE.NLM with the default IRQ 15 configuration. Two interrupt levels are supported by the BC hardware: IRQ 10 and IRQ 15. If the IRQ 10 configuration is preferred, modify the load command as follows:

load bcactive 10 

Note: BCACTIVE must have a command line parameter specifying the IRQ and this must match the IRQ configuration of BCSETUP.

BCACTIVE should not be loaded if BCSETUP is loaded without BC Supervisory System support (bcsetup.sys -I=NO)

This document, and all Web contents, Copyright © 1997 by Cubix Corp., Carson City, NV, USA.